Cleaning Flame Sensor On Rheem Furnace
Cleaning Flame Sensor On Rheem Furnace. Remove the lower front panel from the heater to access the burners. If the flame sensor is definitely the culprit, you can purchase a new one from repair clinic.
Use a screwdriver or wrench to unfasten the screws holding the flame sensor in place. Normally, the sensor bents and sits just in front of the pilot flame inside the furnace system. If cleaning your flame sensor did not work, it’s possible that the sensor is broken and that the furnace is operating as it should.
Remove The Lower Front Panel From The Heater To Access The Burners.
How to clean the flame sensor on rheem heaters turn off the power supply to your heater at the breaker box. Small piece of light grit sandpaper, steel wool, or emery cloth; Remove the lower front panel from the heater to access the burners.
Once You Locate The Sensor, Proceed As Follows;
To clean the sensor, simply rub the metal rod gently with light grit sandpaper, steel wool, or emery cloth to eliminate the carbon buildup. Flame sensors can be found in all modern gas. The flame sensor is just a stainless steel rod that gets cleaned with a green scotchbrite pad.
If The Flame Sensor Is Dirty, Your Rheem Water Heater Will Turn Off After Some Seconds Or Minutes.
If you do decide to remove the flame sensor and clean it, it's always a good idea to also clean the terminal at the base by rubbing it down with acetone or lacquer thinner. Pull out the flame sensor once you locate it. When the thermostat indicates that the furnace to turn on, the gas valve opens up and fires gas into the combustion chamber where the ignitor or pilot lights the burners.
Normally, The Sensor Bents And Sits Just In Front Of The Pilot Flame Inside The Furnace System.
How to clean the flame sensor on rheem heaters | hunker If cleaning your flame sensor did not work, it’s possible that the sensor is broken and that the furnace is operating as it should. After cleaning the flame sensor, checking ground wire, checking exhaust for cracks or blockage and the board connection which did not fix it.
Your Rheem Water Heater Will Also Show 6 3 Flashes.
Scrub until you’ve removed all traces of rust, dust, grit, and grime. You’re not sanding down a rusty car, here; To get started, locate the flame sensor by following the steps in the “where is the flame sensor on the furnace” section.
Post a Comment for "Cleaning Flame Sensor On Rheem Furnace"