How To Change Crankshaft Sensor
How To Change Crankshaft Sensor. This will drain all of the power from the electronics and clear any short term memory. The crankshaft sensor on gmc vehicles is synced to the powertrain control module, or pcm.
The proper procedure for resyncing or relearning the crankshaft position is called the ckp variation learn. Secure the vehicle in this position using jack stands. Compare the old sensor to the new one to ensure a correct fit.
Push A New Sensor Into The Hole, Thread The Bolt In And Snug It Down Hand Tight.
On the bright side, the cost of a replacement isn’t too high, either. When the crank sensor is replaced, it must be resynced to the pcm. It's best to use an oem part.
Unplug It From The Wiring Harness.
Ratchet and socket set (1/4” or 3/8” drive) new crankshaft position sensor. The crank sensor might have a. Compare the old sensor to the new one to ensure a correct fit.
Plug In The Crank Sensor's Wiring Harness Connector.
If playback doesn't begin shortly, try. If the crankshaft sensor malfunctions, the vehicle may or may not run, depending on the year and the type of electronic. Crankshaft sensor replacement replacing a crankshaft position sensor is not very expensive.
If The Frequency Is There, The Problem Is Elsewhere.
Jack the vehicle up high enough to obtain access to the crankshaft position sensor. To reset the check engine light you can disconnect the battery via the negative battery terminal and let the vehicle sit for an hour before reconnecting the battery. Do this easy job yourself, with simple tools, and save $$$!
In Most Cars It's Fairly Easy To Replace, Although Sometimes The Sensor Could Be Difficult To Remove Due To Corrosion.
The scan tool should read between 100 and 500 rpm. Since the engine will not start, there is no waveform. Installing the new crankshaft position sensor.
Post a Comment for "How To Change Crankshaft Sensor"