Cleaning Flame Sensor With Dollar Bill
Cleaning Flame Sensor With Dollar Bill. When the sensor has been accessed, use fine sandpaper or something a bit abrasive like a dollar bill to wipe down the sensor. Cleaning a flame senser with a dollar bill?!
I also found that the stack thermostat had to This video is a great reference for cleaning the flame sensor: In the video, you can see 4 burner ports.
Use Something Abrasive Such As A Dollar Bill, Fine Sandpaper, Or Even An Emery Cloth.
I've never had an issue. If present, you should also clean off any corrosion where the power wire connects to the flame sensor terminal. Just unscrew one screw, remove the whole sensor unit, use some steel wool to clean it, reinsert, and the problem is solved.
Then The Tube And The Bottom Of The Combustion Fan Fill With Water.
They say it took them 10 minutes to blow the dust off and used a dollar bill to clean sensor and ignitor. Turn on the water heater. Clean the flame sensor i prefer using a scotch pad.
Cleaning A Flame Senser With A Dollar Bill?!
I was going to take it apart to make sure, but after shining a flashlight on all the burners it doesn't seem necessary. A dollar bill won't cut it. Just want some fact on cleaning flame sensers.
If You Don’t Have One, Then A Dollar Bill Works Fine.
Just fold the bill over the rod and, while tightly gripping it, rub it back and forth until the rod becomes somewhat shiny. The best way to clean it is by using a dollar bill. Use a piece of rough paper, light sandpaper, or a dollar bill to rub the residue off the flame sensor.
Upon Removing This Screw, The Sensor Will Slide Out So That You Can Easily Clean It.
I have even used a small wad of fiberglass insulation to clean one. Check the flame sensor to be sure that is clean. I also found that the stack thermostat had to
Post a Comment for "Cleaning Flame Sensor With Dollar Bill"