How To Change A Oil Pressure Sensor On A 2008 Chevy Silverado
How To Change A Oil Pressure Sensor On A 2008 Chevy Silverado. Thanks for the feed back with this. Replaced the afm screen just below the oil pressure sending unit & everything is back to normal.
This p0521 diagnosis order is written (like everything on the site) for the diy guy who doesn’t have a lot of specialty tools. The oil pressure sensor or switch on your chevy silverado is designed to warn you of very low oil pressure, preventing engine damage that can occur if you drive your truck with no oil or low oil pressure. It's a common issue for it to go bad.
The Oil Pressure Sensor Assumes The Role Of Monitoring This Internal Pressure And Sending A Signal To The Oil Pressure Gauge On Your Dash, Alerting You Immediately If There Is A Problem.
If your silverado’s sensor has gone bad, it’ll shoot a false low pressure reading to the ecm. Take it to the mechanic Use the 1/16 deep well socket, ratchet, and extension to loosen the switch.
The Engine Is Started And Oil Pressure Is Checked Then The Vehicle Is Taken Off The Jack Stands.
Its vehicle brand lineup includes buick, chevrolet, gmc and cadillac. It's a common issue for it to go bad. My symptom was the oil pressure gauge pegged at 80 psi on my 2007 gmc sierra classic.
With The 2013 I Would Stay With The Ac Delco.
It lies at the front of the transmission bell housing, and you need a special tool to access the same. The oil pressure sending unit, also called an oil pressure switch, is a component of the engine mechanical system. The oil pressure sensor or switch on your chevy silverado is designed to warn you of very low oil pressure, preventing engine damage that can occur if you drive your truck with no oil or low oil pressure.
One Of The First Things That People Do When They Have The Low Oil Pressure Light Is To Change Out This Sensor To See If That Rectifies The Problem.
The oil pressure sensor also feeds your oil pressure gauge and sends data to the engine computer in newer silverados. Make sure the engine is hot and allow time 30 min for the oil to drain.use high quality oil filters. The defective oil pressure sensor is removed.
Replaced The Afm Screen Just Below The Oil Pressure Sending Unit & Everything Is Back To Normal.
The same goes for the 2009 chevy silverado 5.3 sensor location. This gives the driver time to pull over and assess the problem before costly repairs become necessary. Here’s a good article on how to check the oil pressure sensor from itstillruns.
Post a Comment for "How To Change A Oil Pressure Sensor On A 2008 Chevy Silverado"