How To Reset Fuel Tank Pressure Sensor
How To Reset Fuel Tank Pressure Sensor. The later is located inside or next to the fuel tank and. If the fuel tank pressure data is out of spec, a mechanic will inspect the wiring going to the fuel pressure sensor.
Check the ftp sensor with the scan tool view dtcs. The tank needs to be dropped in order to service the pressure sensor. P0192 you need to check the fuel pressure, fuel filter , fuel pump strainer, which ever will cause low fuel pressure, if you ever set a p0193 and the connection to the fuel rail pressure sensor is connected, there no need to check fuel pressure , you replace the fuel pressure sensor.
The P1457 Fuel Tank Pressure Circuit High Should Be Active Or Pending With The Connector Disconnected.
The fuel tank pressure (ftp) pressure sensor detects pressure in the purge line. Yes, verify that is good pin to terminal contact in the ftp sensor and powertrain control module (pcm) connectors. The ftp sensor is a transducer that varies resistance according to changes in the fuel tank pressure.
The Engine Control Module Monitors The Ftp Sensor Signal In Order To Detect Vacuum Decay And Excess Vacuum During The Evap System Diagnostic Test
It's not real common for them to go bad and there are several other possibilities that can make this code appear. The later is located inside or next to the fuel tank and. Does the scan tool display as described above ?
It Would Be Nice If You Could Oust The Actual Code You Are Getting Also.
The evap system is designed to keep all gasoline vapors within your car’s fuel system, after you have fueled it up at the gas station. Disconnect the glow plug module and the exhaust gas recirculation temperature (egrt) sensor electrical connectors, detach the wiring retainer and position the wiring harnesses aside. Turn ignition key to the on position.
Signs Of A Bad Fuel.
The fuel tank pressure sensor does all this by monitoring the pressure, both positive and negative, inside your fuel tank. The tank needs to be dropped in order to service the pressure sensor. Cel came on for the first time in 162k miles.
During Normal Driving The Ftps Is Monitored To Ensure It Changes By More Than 0.03Kpa, If Not The Fault Code Is Flagged.
As you can see its attached to the main evap line. Do not confuse the fuel rail pressure sensor with the fuel tank pressure sensor. If the vent valve comes on, and the pressure sensor is.
Post a Comment for "How To Reset Fuel Tank Pressure Sensor"